Maximal shearing strength at the bone HA interface.
骨—HA界面的最大剪切强度。
And the index of tenderness is expressed with shearing strength.
嫩度指标应以剪切应力值表示。
Unloading paths have little effects on the shearing strength parameters.
卸荷应力路径对土体的强度参数影响不大。
Factors affecting the shearing strength of cemented casing are investigated.
考察了粘砂套管剪切强度的影响因素。
Vancomycin fermentation needs high dissolved oxygen and is not very sensitive to shearing strength.
万古霉素的发酵对溶氧要求高，而对剪切力不太敏感。
The correlation between LVL's shearing strength and density of wood species and LVL is not prominent.
剪切强度与树种密度间、与LVL密度间的相关性很差。
The effects of toughener and filler on shearing strength and impact strength of epoxy adhesives were studied.
研究增韧剂、填料对环氧树脂胶粘剂剪切强度和冲击强度性能的影响。
Tested data show that the shearing strength of aluminum plate base treated by the method is increased by 82.2%.
实验数据表明，经此法处理的铝板基剪切强度提高82.2%。
The shearing strength at the foundation, where the concrete is placed on a smooth rock surface, may be lessened.
当混凝土浇筑在平滑的岩石表面时，地基上的剪切强度可能会减少。
VES-SL system is superior to HPG fracturing fluid in anti-degradation and shearing strength, and has better mobility.
SL压裂液的抗热降解和剪切降解的能力强于HPG压裂液，且具有很好的流动性。
VES-SL system is superior to HPG fracturing fluid in anti- degradation and shearing strength, and has better mobility.
VES-SL压裂液的抗热降解和剪切降解的能力强于HPG压裂液，且具有很好的流动性。
The research results for shearing strength behaviours of typically overconsolidatedfissure clays are given in the paper.
本文是对典型超固结裂隙粘土强度特性的研究结果。
The effect of the shearing strength indexes variation and the density variation of tailings on reliability index is analyzed.
探讨了材料的抗剪强度指标和密度的变异性对坝体可靠指标的影响规律。
Shearing strength of concrete and limestone and limestone is mostly controlled by cementation strength for concrete and limestone.
混凝土与灰岩的抗剪强度主要受混凝土与灰岩的胶结强度控制。
A new physical conception by introducing parameters as the indexes of cohesive soil's shearing strength is presented in this paper.
本文对粘性土抗剪强度指标参数提出新的物理概念。
The other quality of the soft clay includes smaller shearing strength intensity and higher coefficient of compressibility and so on.
软土在我国广泛分布，软粘土的显著特性是含水量高、孔隙比大，抗剪强度及渗透系数低和压缩性、灵敏度高。
Precipitation uplifts ground water level and weakens shearing strength of soil, thus results in large displacement in side direction.
大气降水抬升了地下水位，并削弱了土体的抗剪强度，从而使得土体的侧向位移迅速增大。
This thesis has created a new rheological model by discussing the rule of pure cement's shearing strength varied with the shearing time.
通过讨论纯水泥浆液随剪切速率的变化，剪切应力的变化规律，来建立新拌水泥浆体的流变模型。
With the aid of triaxial compression test, the shearing strength and strain-stress relationship characters of compacted loess is discussed.
通过常规三轴试验研究了压实黄土的强度指标和应力—应变关系。
Develop the binding material which resist high shearing strength, low and high temperature is the key to solve the disease of asphalt overlay.
开发抗剪强度高、抗高低温性能好的粘接材料，是解决在沥青面层车辙、拥包、推移等病害的关键。
The BP artificial neural network prediction model is established for forecasting the shearing strength of new to old concrete with cutting groove.
利用BP人工神经网络对沟槽式新老混凝土的抗剪强度进行了模拟和预报。
The soft ground has characteristics such as rich natural water content, big air space ratio, high compressibility, low shearing strength and so on.
软土地基具有天然含水量大、空隙比大、压缩性高、抗剪强度低等特点。
The results show that the shearing strength of the interface between clad layer and substrate is higher than of substrate and clad layer of some alloys.
熔覆层与基材交界处的剪切强度比热影响区高，并比某些合金的熔覆层高。
Based on the Cone Index bearing capacity and shearing strength of paddy in Hunan Province, we designed the lug wheel for powered tiller in this province.
根据湖南省一般淹水水田和旱态水田的圆锥指数承压特性及土壤力学参数剪切特性来设计湖南独轮耕整机的驱动轮。
The shearing strength of reinforced concrete rectangular slabs supported on four sides with ratio of side length between 2 and 3 are studied in this paper.
对边长比为2 ~3的四边支承矩形板的抗冲切性能进行了试验研究。
The destruction of soil is shearing in effect, but the representation of soil anti-shearing strength is closely related to the mode of external load action.
在水力侵蚀作用下黄土破坏实质上是剪切破坏，但土壤抗剪强度表现形式与外载荷作用形式密切相关。
Under the higher confining pressure, the shearing strength and the differential stress between the compression strength and confining pressure tend to be the constant.
至更高围压后，抗压强度与围压的应力差、抗剪强度将趋于某一常数。
The results showed that the percentage cell disruption was proportional to feeding rate which determined the magnitude of shearing strength causing the cell disruption.
结果表明，膜表面的流动速率与细胞破损率呈正比，流速与细胞破损率同比例增大。
The paper was discussed the influence of system parameters of extrusion on shearing strength and sticking to the screen during the solvent extraction of extruded corn germ.
探讨用于浸油的玉米胚挤压膨化预处理过程中的挤压系统参数对膨化物剪切强度和浸出过程中糊底程度的影响规律。
The paper was discussed the influence of system parameters of extrusion on shearing strength and sticking to the screen during the solvent extraction of extruded corn germ.
探讨用于浸油的玉米胚挤压膨化预处理过程中的挤压系统参数对膨化物剪切强度和浸出过程中糊底程度的影响规律。
应用推荐