Static trials represent an experimental test method of defected mode and static strength of a plane construction.
静力测试提供了一种检测飞机机体结构破坏模式以及静强度的试验方法。
The static strength has been regarded as the main design standard in port crane design for many years.
多年以来，港口起重机设计大都将静强度作为主要设计准则。
The relationship between dynamic and static strength of soil is worth discussing.
土的动强度与静强度之关系，国内外学者的研究成果不尽一致。
By application the reliability design methods, the static strength of pressure spherical vessel is analyzed.
应用可靠性设计方法，对球形容器的静强度进行分析。
And the research about seat safety concentrates on the analysis of static strength, impact strength and fatigue strength.
与安全性相关的研究主要围绕座椅的静强度、冲击强度以及疲劳强度的分析。
Basic static strength rating, or for hand operation of above gears , is approximately 3 times the 100 RPM rating. Note:1.
基本静力强度的额定值，或者针对以上齿轮的手工操作，大约是每分钟100转的额定值的3倍。
Study on the influence of constitutive parameters of rubber on static strength of the resilient wheelset is also carried out.
同时，研究了橡胶的本构参数对弹性轮对静强度的影响。
Using I-DEAS software, finite element analysis of static strength of low-sided weathering steel gondola car body is carried out.
利用I -DEAS软件，对低边耐候钢敞车车体钢结构进行有限元静强度分析。
The failure patterns of rock was formerly only studied on the bases of static loading and the static strength theory was adopted.
以往研究岩石的破坏类型只停留在静载作用下，而其强度理论也多采用静态强度理论。
The static strength and stiffness of the framework of motor-reversing type pumping unit is analyzed by the finite element method.
应用有限单元法对电动机换向抽油机支架进行了静态分析，计算其静强度和刚度。
This paper studies the evaluation method of static strength reliability on 3-dimensional model for off-shore platform structure system.
本文研究了对三维模型的导管架平台结构系统静强度可靠性评估方法。
This paper analyses and studies the effect of residual stresses on static strength, stability, and fatigue strength of the steel members.
文章就钢构件中的残余应力对钢构件的静力强度、稳定性及疲劳性能的影响进行了分析和研究。
Based on the uncertain non - probabilistic convex models, the non - probabilistic reliability design of shaft on static strength is proposed.
基于不确定非概率凸模型，提出了轴静强度的非概率可靠性设计方法。
Beside the interesting shape, the result is also great static strength, which obviates the need for any additional supporting sub-construction.
除了形成有趣的外形外，这种设计还带来很大的静强度，使得不再需要任何其他支持性次级建筑。
This paper gives main functions of a general purpose program called SAPFEM for static strength analysis of structure by the finite element method.
本文介绍了作者研制的709机结构有限元静力分析通用程序SAPFEM的主要功能。
Described are the lightening design, energy absorption car-body design, finite element analysis, static strength test and modal analysis calculation.
介绍了北京八通线地铁车体钢结构的轻量化设计、吸能车体设计、有限元分析、静强度试验和模态分析计算。
The aim of induction quenching has been enlarged from only improving local wear resistance to improving whole static strength and fatigue strength of parts.
感应淬火的目的已从仅仅提高零件的局部耐磨性扩大到提高零件的整体静强度和疲劳强度。
By using reliability design methods, minimal reliability of virgin static strength of steel thin wall cylinder during pressure test is quantitative analyzed.
应用可靠性设计方法，对压力试验时钢制薄壁内压圆筒形容器初始静强度的最小可靠度进行了定量分析。
As for a propeller of a tugboat, it is necessary to calculate the fatigue strength in the self running state as well as the static strength in the bollard state.
对拖船螺旋桨来说，除了应计算系桩状态的静态强度外，还应计算自由航行状态的疲劳强度。
By using reliability design methods, minimal reliability of virgin static strength of flat ribbon-wound pressure vessels at pressure test is quantitative analyzed.
应用可靠性设计方法，对压力试验时扁平绕带式容器初始静强度的可靠度进行定量分析。
Simultaneously about as 2/3 static strength as dynamic strength at same failure strain under equipressure consolidation condition of mucky soil in Xiamen is gotten.
同时得出厦门淤泥土在等压固结条件下相同破坏应变的动强度约为静强度的2/3。
The law shows that, along with the static pre-load increasing, the dynamical bending strength of concrete would go up to a peak value and then move downward to the static strength.
计算结果显示，不同细观骨料模型具有相似的规律，即随预静载增大，混凝土动弯拉强度上升，至一定峰值后回归到静载强度。
During the new style racing car's design, it is an important task to analyze the reasonableness of the racing car's frame structure and calculate its static strength and stiffness.
在新型赛车的开发设计中，计算与分析车架结构合理性及其结构静态强度和刚度，是一项重要工作。
In the static strength analysis of helicopter blade, the traditional analysis method may lead to the uncertainty of the strength conclusion due to the inaccuracy of load calculation.
在直升机桨叶的静强度分析中，传统的分析方法可能会由于载荷计算的不准确，给强度结论带来不确定性。
The test result showed that the ratio of dynamic strength and static strength is 1. 25 ~ 1 '30, by which the value of low temperature tensile strength of material could be evaluated.
实验结果表明，动态强度与静态强度的比值为1.25 ~ 1.30，利用此关系可以估算材料的低温抗拉强度值。
Then the article conducts static analysis of the body frame under bending and torsion condition, so that preliminary to assess the risk static strength location of the body structure.
然后分别对车身骨架进行了弯曲和扭转工况下静态分析，初步评估车身结构静强度危险位置。
The paper discusses the failure mechanism of structural system subjected to dead and fatigue load and gives the method of reliability analysis considering static strength and fatigue.
具体分析了结构系统在静载和疲劳载荷作用下的失效机理以及各失效模式之间的相关性，给出了在静载和疲劳载荷作用下结构系统的可靠性分析方法。
Also, the calculation formula of the contact stress, the fatigue strength and the static strength for the small thrust bearing which are attached at the end face of roller are derived.
同时又对滚子端面的小型推力球轴承推导出接触应力、疲劳强度和静载强度的计算公式。
The results showed that the statistical characteristic for static strength and residual fatigue strength of carbon epoxy laminates could be properly described by this distribution model.
结果表明，这一分布模型能够更全面地描述复合材料层板静态强度和疲劳剩余强度的统计特性。
The results showed that the statistical characteristic for static strength and residual fatigue strength of carbon epoxy laminates could be properly described by this distribution model.
结果表明，这一分布模型能够更全面地描述复合材料层板静态强度和疲劳剩余强度的统计特性。
应用推荐