Using the temperature control system, the temperature of this room stays at 28 degrees.
设施到位，这个房间的温度总保持在28度。
This method is used in the temperature control system of horse-shoe flame glass furnace.
并将此方法应用于蓄热式马蹄焰玻璃熔炉的温度控制系统。
Mainly used in the temperature control system of exhaust air of the compressor of the air conditioner.
主要用于空调压缩机排气温度控制系统。
A kind of parameter self-regulation fuzzy controller used in the temperature control system of furnace is introduced.
介绍了一种用于炉温控制系统中基于参数自调整的单片机模糊控制器。
Electrothermal membrane heating, is made of carbon fiber cotton on the heating body and the temperature control system.
电热膜地暖，是由碳纤维棉上发热体和温控器系统组成。
The temperature control system for macromolecule polymer reaction is designed by the method of Fuzzy_Neural PID control.
应用模糊神经网络PID控制技术，建立了高分子聚合物反应温度控制系统。
Auto-Thermal Switch (ATS) is an auto reset device that connects into the temperature control system for safer operation.
自动热量转换器(ats)，是连接到温度控制系统上的安全操作自动按钮。
In the development of biochemistry analysis instrument, one important constituent is to study the temperature control system.
在生化分析仪的开发研制中，一个重要的组成部分是温度控制系统的研制。
A fuzzy controller with integral parameter is designed, and applies it to the temperature control system of resistance furnace.
设计了一种带有积分参数的模糊控制器，并将其应用于电阻炉的温度控制系统。
Because the temperature control system is a pure time delay system which will cause system unstable or reduce work performance.
由于温度控制系统为纯滞后系统，纯滞后会引起系统的不稳定或降低系统的工作性能。
The structure of the temperature control system of the gas fired furnace for heating of the big aeronautic forge piece is studied.
研究了供航空大锻件加热用煤气炉控温系统的结构。
On this basis, the temperature control system for this type stack is designed, and the fuzzy-PID fusion control algorithm is used.
在模糊预测函数控制的基础上，建立了一种新型算法来预测高炉铁水硅质量分数。
The Wetting Balance Tester includes the motion system, the temperature control system, the testing system and the data processing part.
润湿力测量仪包括运动系统、温控系统、测试系统和数据处理四部分。
It was mainly composed of the (vibrating) sensor, the temperature control system, the pressure control system, and the signal adjust system.
振动丝黏度仪主要包括振动丝传感器、温度控制系统、压力控制系统和信号调节系统。
Puts forward a new kind of online interpolation fuzzy control method, and at last the controller is applied in the temperature control system of furnace.
本文提出了一种在线插值模糊控制方法，设计了在线插值模糊控制器，并在炉温控制系统中应用。
The experimental result shows that the temperature control system can keep the uncooled infrared detector operating at the optimal temperature accurately and stably.
实验结果表明，该温控系统能够使非致冷探测器精确、稳定地工作在最佳温度点。
According to the requirement of temperature control, the fuzzy-PID control arithmetic has been put forward and applied to the temperature control system of casting roller.
根据温度控制需求，提出了模糊pid控制算法，并将其应用到流涎辊温度控制系统中。
A design procedure with constant parameter frequency method is developed for the temperature control system with variable parameter applicable especially to thermodynamics.
提出了热工专业中特殊的变参数控制系统的定参数频率设计法，应用计算机进行了仿真计算并进行了实际系统的测试。
The experimental results show that the temperature control system fully meets the requirements of the temperature stabilization of each sensitive element on the focal plane.
通过实验对所设计的温控系统进行了测试，测试结果表明，所设计的温控系统完全符合焦平面上各敏感元对温度稳定性的要求。
The temperature control system of box heat-treatment furnace based on PLC was designed, including hardware system, temperature control program and testing of control program.
设计了以可编程控制器(plc)为核心的箱式热处理炉温度控制系统，包括硬件设计、控制程序设计及调试。
The temperature control system with high precision and fast response was used for the aided experiment on measurement of water activity, and it achieved a good control effect.
该温度控制系统用于水分活度测量辅助实验，精度高、响应快，获得了良好白勺控制效果。
This paper describes the hardware and software design of temperature control signal output channel based on 8098's HSO in the temperature control system of SCR power regulating.
介绍在晶闸管调功温控系统中，采用8098单片机的高速输出通道（HSO）作为温控信号输出通道的硬件和软件设计。
The temperature control system based on DS18B20 adopts C8051F020 and its external interface circuit to carry out the measurement control for direct current manostat power temperature.
基于DS18B20的温度控制系统，利用C8051F 020及其外围接口电路对直流稳压电源温度进行测量控制。
It analyzes the basic structure of the double-deck injection mould, describes how to design the temperature control system and mechanism for mould opening. The paper shows an example.
首先分析了叠式模具的基本结构，然后阐述了温控系统、开模机构的设计与选择，最后给出一个具体的设计实例。
The principle of dynamic matrix control(DMC) was studied, and the application of DMC algorithm on the temperature control system for thermal field of single crystal growth fumace was given too.
研究了动态矩阵控制（DMC）算法在单晶炉热场温度控制系统中的应用。
This paper introduces briefly the composition of the temperature control system of strip steel in induction heating. Mathematical model of the system is established and computer simulation is made.
介绍了带钢感应加热温度控制系统的组成，建立了系统的数学模型，并对该系统进行了计算机仿真。
The practical result shows that the Temperature Control System is adapt to some complicated industry environment with many advantages such as high-speed, easy-controlled, high-reliability, and so on.
现场运行表明，该系统具有速度快、控制方便、可靠性高等优点，能够适应工业现场等较复杂恶劣的环境。
Practical results show that the temperature control system with ensure-transition program design is a high efficiency and energy saving system, and has high temperature control accuracy and stability.
实际结果表明：采用确保转换程序设计的温控系统高效节能，具有较高的温度控制精度及稳定性，使退火过程中炉温超调量大的问题得到了很好的解决。
Based on the process control experience in a paper mill in Shandong province, the improvement of the temperature control system of the starch cooking and the component of the whole DCS are introduced.
陕西科技大学，陕西咸阳，712081摘要：结合山东某厂纸板生产过程的控制系统，介绍了对淀粉液温度控制系统的改进及整个DCS系统的组成。
Based on the process control experience in a paper mill in Shandong province, the improvement of the temperature control system of the starch cooking and the component of the whole DCS are introduced.
陕西科技大学，陕西咸阳，712081摘要：结合山东某厂纸板生产过程的控制系统，介绍了对淀粉液温度控制系统的改进及整个DCS系统的组成。
应用推荐