Measuring valve spool with holes and gaps, valve hole diameter is 50?
测量阀孔和阀芯的配合间隙，阀孔直径为50 ？
Pneumatic valve works by rotating the valve spool to flow or occlusion.
气动球阀的工作原理是靠旋转阀芯来使阀门畅通或闭塞。
A proportional valve spool therefore has wider lands with notches cut into the edges.
比例阀阀芯具有比较宽的边缘带有槽口的台肩。
At present, hydraulic valve has the deficiency of inadequate interchangeability and machining difficulty of unsymmetrical valve spool.
目前，液压阀存在互换性差、不对称阀芯的设计加工困难等不足。
Nozzle; High quality'kerric'faucet, and its valve spool are used the international porcelain valve spool, its surface is coate with epoxy resin power.
水嘴：采用“科艺牌”全铜质精铸成型实验室专用水龙头，阀芯采用国际通用的瓷阀芯，表面经环氧树脂粉沫喷涂处理。
By changing the balance valve spool of the flow area to adapt to the changes before and after the valve, so as to achieve the purpose of flow control.
通过改变平衡阀的阀芯的过流面积来适应阀门前后的变化，从而达到控制流量的目的。
Adjusting mechanism is the executive body converts the output of displacement control valve spool and valve seat area change between the flow of the device.
调节机构是将执行机构的输出位移变化转换为控制阀阀芯和阀座间流通面积变化的装置。
Spool valve is composed of valve spool and valve sleeve, and as the power stage of servo valve, it has a high degree of accuracy and is difficult for machining.
滑阀是由阀芯和阀套两部分组成，通常用作电液伺服阀的功率放大级，其精度要求高，加工难度大。
It can be concluded that cavitation of hydraulic cartridge cone valve is reduced by increasing the opening stroke and the outlet pressure and changing the geometrical structure of valve spool.
研究表明：增大阀口开度，增大出口压力，并对阀芯结构进行修改后，插装型液压锥阀阀口气穴现象均可有效减弱。
Check valve and butterfly valve combinations are very popular; normally a short spool piece is required between the valves.
止回阀与蝶阀的连接是经常发生的事，通常需要在这两种阀门之间加上一节短短的阀槽。
The valve is driven directly by a large strake multilayer piezoelectric stack, its displacement actuates the power cascade spool after amplification by a lever mechanism.
该阀采用大行程的压电叠堆作为驱动元件，经杠杆放大后的位移直接驱动功率级滑阀。
By varying the current to either solenoid, the amount of spool movement can be varied and hence the amount of flow through the valve can be controlled.
通过改变两个之一电磁铁的电流，阀芯移动的位移能够被改变，因此控制了通过阀的流量。
According to flow in a different, balanced spool valve the pressure can be pre-pressure, can also be a back pressure valve.
根据流向不同，平衡阀芯所受的压力可以是阀前压力，也可以是阀后压力。
These valves contain two coils and one valve body and spool assembly.
这些阀门包含两个线圈、一个阀体和阀芯总成。
When the control valve when the reverse, so that both fluid along the direction of movement of spool when closed, the flow control valve capacity will be increased.
当调节阀反向使用时，既流体沿着使阀芯关闭的方向流动时，调节阀的流通能力会增大。
Solenoid operated, spool valve available with anodized aluminum or 316 stainless steel body. Pressures 35-150 psi.
螺线管操作，滑阀可与铝阳极氧化或316不锈钢体。压力35- 150倡议。
Therefore, regulating valve will produce a strong shock and a harsh noise, resulting in fracture spool quickly.
所以调节阀会产生强烈的震荡并发出刺耳的噪声，因而导致阀芯很快断裂。
To maintain the spool in the head and valve seat rings for tight closure is important.
保持阀芯头与阀座环对中，对于严密关闭是重要的。
The new processing spool valve seat must meet the requirements of the drawings.
新加工的阀芯阀座一定要符合图纸要求。
Right In the fluid control and shut down and so on, spool orientation is important for the spool valve core and valve.
对于流体的控制和关闭等，阀芯的导向十分重要，阀芯导向用于阀芯和阀座的对中配合。
To improve the response speed of on-off solenoid valve of big flux, detailed analysis on poppet valve is given and an on-off solenoid valve with movement of both spool and cover is designed.
通过对锥阀特性的分析，设计了一种阀芯、阀套同时运动的芯套双动高速开关阀，该阀增大了高速开关阀的开口度，提高了响应速度和流量。
According to the poor linearity of pressure characteristic in a type of electric water valve, the optimization and calculation process of the spool structure was given in this paper.
针对某型号电动水阀压力特性线性度差的问题，对阀芯结构进行优化设计，给出了阀芯的设计和计算过程。
The power stage of servovalves is spool valve, playing the role of hydraulic pressure amplifier.
电液伺服阀的功率级一般为滑阀，起液压放大器的作用。
The paper USES spool valve system drawing equivalent to cartridge valve system drawing to design a typical hydraulic closed-circuit system consisting of two-way cartridge valve.
本文采用滑阀系统图等效成插装阀系统图的方法，设计出一种由二通插装阀组成的典型闭式系统。
The utility model relates to a vacuum gaining device, in particular to the improvement of a sliding valve in the sliding spool vacuum pump.
本实用新型涉及真空获得设备，特别是滑阀式真空泵中滑阀的改进。
From fluid flow momentum theory the basic equation of flow dynamic forces in the spool closing process is derived, and the spool dynamic equation of the two-way cartridge valve is established.
本文根据流体动量理论导出了阀芯关闭过程中液动力的关系式，在此基础上建立了二通插装阀阀芯关闭运动方程。
The resulting differential pressure is applied to the ends of the spool valve, raising it from its spring-centered null position.
结果导致滑阀端部产生差压并将其自弹簧中心电气零位提升。？
In jet oil hydraulic spool valves, the oil flows through a rush path because of the shape changing of the valve.
流体在通过直喷式柱型液压控制阀阀芯时，阀内形状的变化使流体的运动量发生变化。
In jet oil hydraulic spool valves, the oil flows through a rush path because of the shape changing of the valve.
流体在通过直喷式柱型液压控制阀阀芯时，阀内形状的变化使流体的运动量发生变化。
应用推荐