Press the "reset" key and deletes the zero position error caused by the shift of the zero point in the sensor.
“清零”键，清除传感器因零点飘移而产生的零位误差。
If the spring machine after each zero zero position is not accurate, it may be the problem of driving parameters.
若是弹簧机每次归零以后零点位置都不准确，那就可能是驱动参数的问题。
The apparatus and method thereby compensates for variations in slave cylinder piston 62 zero position due to clutch wear.
该装置和方法从而可以补偿由于离合器磨损导致的工作缸活塞(62)零点位置的变化。
A single chip computer controlled error compensating system USES digital display of inductosyn to compensate errors of scaled zero position.
介绍一种由单片机控制的误差补偿系统，利用感应同步器数显装置对定尺零位误差进行补偿。
This article introduces a new way which applies absolute zero position system of grating digital readout-instrument to measuring large diameter.
介绍了一种采用光栅数显装置的绝对零位系统进行大直径测量的新方法。
The joint zero position deviations of joint type CMM, which result from assembly technology errors, have an enormous influence on the pose errors of probe end.
关节式坐标测量机的关节零位偏差是由装配工艺误差引起的，对测头末端的空间位姿误差影响极大。
The zero position circuit is designed, so that the absolute speed of zero and zero Angle bit precision align, meeting the requirements of servo control system.
设计了测速零位电路，使测速零位和绝对测角零位精确对准，满足伺服控制系统要求。
Put any control handle to the working position, press the "start" button, the total contactor should not move, then explain the zero position protection has played a role.
把任一个控制手柄拨到工作位置上，再按“起动”按钮，总接触器应不动作，则说明零位保护已发挥作用。
Incremental optical electric axial Angle encoder usually adopts zero position grating providing absolute zero position in order to prevent from data fault during electricity failure suddenly.
为了防止突然断电时造成数据错误，增量式光电轴角编码器通常采用零位光栅提供绝对零位信号。
By installing two photoelectric encoders on the hob axis and workpiece axis, the zero position signals of photoelectric encoders coincident with each mechanical zero of two axis is reasonably set.
自动对刀原理是在滚刀轴和工件轴上各加装一光电编码器，合理设置各轴光电编码器零位信号与各自的机械零位重合。
According to the principle of adjusting the volume-difference between supplied and drawn air, the deviation of zero-position can be quickly regulated by setting feed-forward control system.
零位高度的偏离可通过设置前馈控制系统、调节进排风量差来进行补偿和调整。
According to the principle of adjusting the volume-difference between supplied and drawn air, the deviation of zero-position can be quickly regulated by setting feed-forward control system.
零位高度的偏离可通过设置前馈控制系统、调节进排风量差来进行补偿和调整。
应用推荐