我们也看到了热力学的计算结果，也看到了极限情况的形式。
And so we saw what the thermodynamics worked out to be. And what the limiting cases were.
“我们从最初原则计算，从量子力学和原子的基本认识处罚，没有任何实验输入调整计算结果，”Safronova说。
"We did them from first principles, from a basic understanding of quantum mechanics and atoms, without putting any experimental inputs to adjust the calculations," Safronova said.
计算结果表明，基于钢桥面铺装层带裂缝工作的事实，应用断裂力学方法预测钢桥面铺装层疲劳寿命是可行的。
The result indicates that fracture mechanics can be employed to forecast the fatigue life of the pavement on orthotropic steel bridge decks.
岩土力学参数的概率分布类型直接影响岩土工程可靠性分析的计算结果和精度。
The probabilistic model of rock and soil mechanics parameters affects the results and precision of reliability analysis and design.
计算结果均表明，本文的一维水动力学模型能较好地模拟漫滩河道的过流特征，并改善了漫滩河道洪水演进的模拟与预测能力。
Calculation results show that this model can simulate the characteristics of water flow in a floodplain river and can improve the capacity of flood routing simulating and predicting.
通过对计算结果的比较和分析，对桩顶圈梁作用的力学机理进行了深入探讨；
The mechanics mechanism of lop beam is discussed by the mcthod of comparing and analyzing the results of calculation.
经与弹性力学解析解对比，验证了该程序计算结果是合理的。
The program is validated by comparing its simulation results and the result of elasticity mechanics.
计算结果可作为数控编程时力学仿形的基础。
The result can be used as the base in NC programme dynamic profile modeling.
室温以下的计算结果可以用来补充了热力学数据库信息。
The calculating results below the room temperature can be integrating to the thermodynamic database.
该文利用ANSYS软件，对活塞缸进行了力学分析；并根据计算结果，对由活塞缸引起的引信失效原因进行了详细的分析。
The mechanics analysis is done on the piston jar with the ANSYS software, and the reasons of the fuze failure caused by the piston jar are analyzed in more detail based on calculation results.
计算结果表明：活塞在热冲击期间表现的温度及热应力的动力学效应是必须加以考虑的。
It was shown that the dynamic effect of the temperature and thermal stress of piston must be considered during thermal shock.
计算结果较好地反映了竖井周围岩体不稳定关键块在爆破振动作用下沿断层破坏、崩落的动力学过程。
The result of blasting simulation clearly shows the movement of the silo is due to the unsteadiness jointing rock mass under applied blasting vibration load.
计算结果同时也表明，对于表面覆盖有钝化膜的材料的数值模拟，建立合理的流动腐蚀动力学模型是数值计算方法应用成功与否的关键。
The modeled results also show that the ability to simulate corrosion of materials with surface passive film to some extent depends on their corrosion kinetics process tested by experiments.
计算结果表明，层间水分子含量对材料的力学性质有很大的影响。
Results indicated that the interlayer water content greatly impacted the mechanical properties of the materials.
对有限元计算结果进行分析，了解托轮的力学行为，从而实用于回转窑托轮的设计及调整。
According to the analyzing of finite element computing results, the mechanics action of supporter is obtained, which is the bases for designing and adjusting of rotary kiln.
数值计算结果表明，在考虑到温度观测误差的条件下，所建立的参数反演方法能够有效地识别出混凝土的热力学参数。
The numerical computation shows that the proposed method is able to identify efficiently the concrete thermal parameters while the measurement errors of temperatures are considered.
为实施进一步数值模拟提供了可靠的前提，此项研究的计算结果也为优化血管性介入治疗等提供了血流动力学依据。
The models and the numerical simulation provide reliable fundamental not only for the further numerical simulation but also for the optimization of vascular intervention treatment.
在较低压力下获得的冲击温度与热力学计算结果较为一致。
The shock temperature measured at relatively lower pressure was consistent with the result from thermodynamic calculations.
模型的计算结果与实验结果对比，表明该模型可以反映轮胎非线性侧偏特性，可以用于汽车操纵动力学研究。
The non-linear non-steady lateral force and aligning moment are compared with test data, showing the feasibility of application for the studies of vehicle dynamics.
与其他量子力学计算结果比较，表明这种动力学李代数方法在预言有机共轭分子的非线性光学性质上同样有用。
Compared with other quantum calculations, DLA method appears to provide an effective method for the calculation of the hyperpolarizability of conjugated organic molecules.
计算结果表明，系统加装磁流变阻尼器后，其动力学性能都有明显的改善和提高。
The numerical results show that the dynamic characteristics of structure system using MR dampers have been promoted dramatically.
在计算力学模型相同的条件下，遗传—模拟退火算法的计算结果基本不会大于遗传算法的计算结果。
On the condition of sample calculation mechanical model, Genetic simulated Annealing Algorithms method's calculation results of all more superiority than the calculation results of Genetic Algorithms.
计算结果表明，用该方法计算动力学问题是可行的。
The calculation results show it is practical to deal with the kinetics problem by the stochastic method in the contemporary computing condition.
此法基于力学中的最小功原理。其计算结果与最小二乘法平差结果完全一致。
This method is based on the principle of minimum. work in mechanics, the result of adjustment has exactly the same value as obtained by calculations from the method of least squares.
建立了物料颗粒的动力学模型，计算了颗粒在对撞室内的穿透深度，并将计算结果与试验结果进行了对比。
Kinetic model of the material was developed, and the material penetration length and its velocity at various positions were calculated.
推导了一种自旋固体火箭的流体动力学模型，并通过实例对模型进行了验证计算，计算结果与实际情况基本吻合。
The paper deduced the Fluid dynamics model of Spinning solid propellant rockets, and validated the Fluid dynamics model by analyzing the examples, the result accord with the actual status.
计算结果与实验测量的比较表明：正向动力学方法可将肢体运动状态、肌肉收缩力、神经控制信号等联系起来，求解人体步态的控制模式。
The results show that forward dynamics theory can model the limb movements, muscular forces and neural control signals to simulate the control of a natural gait.
根据化学热力学等温式，导出了一种计算热效应的方法，其计算结果令人满意。
According to the chemical thermodynamics isothermal formula, this paper leads to a new way of counting the heating effect. Its counting result is very satisfying.
对比表明，计算结果和实测结果基本相符，这说明用键合图理论建立火炮浮动自动机的动力学模型是可行的。
It shows, it is practicable to set up a systematic dynamic model of floating automatic gun with the bond graph theory.
计算结果表明超硬涂层材料滚动接触的力学行为和一般的滚动接触的力学行为存在很大的不同，主要表现在对最大剪切应力的影响。
The calculation shows that the dynamical behavior of rolling contact about super hard material coatings is very different from the dynamical behavior of rolling contact about ordinary contact.
应用推荐