其任意一个螺栓松动，也会导致其他螺栓剪断，引起筛机损坏。
Any one of its bolts loose, will lead to other bolt cut, causing damage to sieve machine.
发动机悬置螺栓松动或折断，可造成汽车起步不平稳并伴有异响。
If the fastening bolts for the engine mounting are loosened or broken down, the truck will not be able to start smoothly and accompany with noise.
根据纪录，空压机的连杆由于牢固连杆的螺栓松动曾经甩进去过。
According to the records the connecting rod for the compressor was once thrown out indeed because the connecting rod products were loose.
针对铁路货车心盘螺栓松动折断的问题，分析其原因，并提出防范措施。
Based on bolt looseness broken analysis for railway wagon core plate, puts forward the preventive measures.
然后利用BP神经网络的模式分类功能，进行了螺栓松动程度的损伤识别研究。
Then damage identification of severity of bolt looseness was studied by utilizing the pattern classification function of the BP neural network.
康达化工厂是山西省最早生产螺栓松动剂的企业，并深受汽修业内人士的赞誉。
Kangda Chemical Plant is the first production of bolts loosening agent in Shanxi Province business, are very popular automotive industry praise.
若在履带板螺栓松动的情况下继续运转机器，会使螺栓和履带板之间产生间隙，进而导致履带板的裂纹。
If the crawler plate bolts loose to continue operating the machine will track bolts and gaps between panels, which led to track Crack plate.
某钢厂列吊车梁在工作中，由于吊车工作的动态作用，导致制动梁（连接板）经常发生断裂，固定连接板的螺栓松动。
The brake beam(connecting plate) is often broken, and the bolts for fixing the connecting plate are loosed due to the crane′s dynamic load when D series of crane beams are working in a steel plant.
如果台面索引轴松动，拧紧固定螺栓。
如果螺栓出现松动，则在螺栓规格表扭矩值基础上再增加扭矩。
If the bolts have loosened, increase the torque to the torque value shown in the Bolting Specification table.
装载机工作环境恶劣，振动大，螺栓易松动，因而，引起三漏及其它质量事故。
Due to the adverse operating environment and strong vibration on loaders, bolts are apt to get loose, resulting in leakage or other troubles.
可能受到振动、波动载荷、冲击载荷或动力载荷的内部螺栓应加以保护防止松动。可采用双螺母、防松动垫圈、点焊等。
Internal bolts subject to vibration, fluctuating load, impact load or dynamic load shall be protected against loosening. Double nuts, unti-loose washers, tack welding, etc. shall be used.
试车前务必检查所有螺栓、螺母是否有松动，若有松动的螺栓、螺母必须重新紧固。
Make sure check the bolt and nut before testing run. and if they become less crowded, fastening again.
传感器要采用螺栓固定，保证一定的紧固力矩，长时间使用不会松动。
Sensor bolt to be used to ensure a certain degree of tightening torque, prolonged use will not become loose.
内腔进行去湿处理并检查各连接部位的螺栓、螺母和填料压盖等是否在运输和存放过程中产生松动，如发现应均匀拧紧。
Check the bolt and nut and filling press cover, it it become flexible during the transport or store, screw down it.
机器长时间工作时，会由于机器的振动而导致螺栓和螺母松动。
Long time machine work, because the machine will cause vibration and loosening bolts and nuts.
这些可以通过临时松动丝杠支撑座的固定螺栓查看噪音是否下降以得到确认。
This can be examined by temporarily loosening the mounting bolts and test-run the system to look for any reductions in the noise.
塔机司机在交接班时，应检查各连接部位螺栓的紧固情况，如有松动应及时紧固。
Tower crane driver in the shift, should check the connecting parts of the fastening bolts, such as loose should be tightened.
对10级BY型防松螺母当前运用中存在的个别螺栓折断和螺母松动问题进行了分析探讨，并提出了相应的措施与建议。
The breaking of very few bolts and loosening of nuts existing in the present operation of 10 Grade BY Type check nuts are analyzed and discussed.
同时进一步研究了松动螺栓数量与管道法兰结构的阻抗变化之间的关系。
Furthermore, the relation between number of loosed bolt and the change of impedance curves received on the pipeline flange was also investigated.
每天塔机司机在交接班的时候，要检查各连接部位螺栓的紧固情况，如有出现松动等异常应该及时紧固。
Every driver of the tower crane in the shift, to check the position of the screw bolt fastening connections, if loose, exceptions should be timely fastening.
泵、轴承座、电动机的基础地脚螺栓是否松动；
Pumps, bearing blocks, motor loose Whether or not the foundation anchor bolts;
检查所有基础上的螺母和压紧装置的螺栓是否松动。3.2安装规定每三月把齿轮箱的油更换一次。
1 check all the nuts and bolts compaction device on the basis of whether is loose. 3.2 installation regulations every march the gearbox oil replacement.
本实用新型在拧固后不易松动旋转，有效地提高了轮毂螺栓和轮毂的使用寿命。
The utility model is not easy to loose and rotate after tightening, so as to effectively improve the service life of the hub bolt and the hub.
铲状螺栓以一种紧密、牢固和经济的方式固定零件，解决螺丝容易松动的问题，提高组装的效率。
Spade bolts provide a compact, strong and economical means of locating and retaining parts or assemblies in position. They eliminate the need for loose screws and facilitate assembly operations.
本文论述了连杆螺栓联接松动的机理，并指出横向交变动载荷是使螺纹松动的主要因素。
The mechanism of self-loosening of con-rod bolts is discussed. It was found that trans-verse cyclic load is the most important factor affecting self-loosening of connecting rod bolts .
还有一些开关是在松动盖板紧固螺栓后(即失爆后)才断电，这些都是重大隐患。
Some switches would be shut off only when the fastened bolt of the cover released (the flameproof function lost). Those all would be the important dangers.
新机开车前，先认真核查电路有无漏电、短路、各螺栓结合部有无松动。
Before starting the machine, check and make sure there are no creepage, short circuit in all the circuits, and all the screws and bolts are secured.
新机开车前，先认真核查电路有无漏电、短路、各螺栓结合部有无松动。
Before starting the machine, check and make sure there are no creepage, short circuit in all the circuits, and all the screws and bolts are secured.
应用推荐