Cross section micrographs and adhesion strength of the coatings were analyzed by TEM and scratch tester. The results show that:both the thickness of physical mixed interface layer and Cr bond layer was reduced significantly with the basic pressure decreased.
利用TEM、划痕仪分析了不同真空度下镀层微观截面形貌与结合强度的变化。
参考来源 - 本底真空度对磁控溅射Cr/C镀层微观形貌及结合强度的影响Interlayers and transition layers was introduced to improve the adhesion strength of the coatings.
通过引入中间过渡层的方法来提高涂层与基体的结合强度。
参考来源 - MoSEffects of the components and contents of binders on the thick film properties have been investigated. It was found that when the glass content was 10%, film adhesion strength achieve maximum (11.6MPa).
研究了玻璃粘结剂组成、含量对金属化膜层性能的影响,实验发现当玻璃含量为10%时,Ag导体层与AlN基片之间附着强度最大(11.6MPa);在固含量不变的情况下,随着玻璃含量的增加,方阻逐渐增大。
参考来源 - 应用于AlN陶瓷混合结合厚膜金属化浆料的研究·2,447,543篇论文数据，部分数据来源于NoteExpress
The stability of hydrolysis and adhesion strength of PU are not good.
聚氨酯的水解稳定性较差，粘结强度偏低。
The sample was characterized by melt flow rate and adhesion strength to aluminum.
用熔体流动速度和粘结强度表示试样的特征。
The adhesion strength and stripping and splitting prevention measure were also discussed.
同时研究了涂料的粘附强度、防裂、防剥落等措施。
应用推荐