... buffer length 缓冲器长度 buffer loop 缓冲循环 buffer management interface 缓冲区管理接口 ...
基于8个网页-相关网页
loop buffer length 环缓冲区长度 ; 循环缓冲区长度
loop buffer 循环缓冲器
loop - buffer 环形缓冲区
dual-loop optical buffer 双环耦合全光缓存器 ; 双环结构缓存器
loop buffer storage 环形缓冲区
loop data buffer 环形数据缓冲区
First of all, notice that you are potentially doing a lot of unnecessary work when the buffer runs out, since you are processing two buffers for each loop iteration.
首先注意，当缓冲区用尽时，可能要做许多不必要的工作，因为对于每个循环迭代都要处理两个缓冲区。
You then use register 127 as your loop counter and register 126 as your base pointer, and perform convert_to_upper on each value until you get to the end of the buffer.
然后再将寄存器127用作循环计数器，将寄存器126用作基指针，并在每个值上执行convert _ to_upper，直到到达缓冲区的底部为止。
As shown in Figure 2-9, the guard buffer significantly reduces the charging time of CSHUNT because of the open-loop gain (AGUARD), which is typically 104 to 106.
如图2 - 9所示，由于保护缓冲放大器具有典型值为104到106的开环增益，所以能够大大减少CSHUNT的充电时间。
应用推荐