Because of the complexity of geometric tolerance, the amphasis of the research in computer aided tolerancing focus on dimensional tolerances. Seldom attension was paid on geometric tolerances.
由于形位公差较为复杂,使得当前计算机辅助公差设计的研究侧重于尺寸公差,而很少关注形位公差。
参考来源 - 尺寸公差与形位公差的计算机辅助混合设计研究The method can be used to synthetically design dimensional tolerance and geometric tolerance. Examples are analyzed to show the scheme to be effective.
此方法可适用于尺寸公差和形位公差综合设计，实例分析验证了此方法的有效性。
参考来源 - 基于变动几何约束网络的形位公差设计理论与方法的研究·2,447,543篇论文数据，部分数据来源于NoteExpress
Size tolerance, surface roughness, geometric tolerance and material requirements are supposed to be contained in technical requirements.
技术要求应包括尺寸公差，表面粗糙度，形位公差，材料等要求。
It is reasonable that the geometric tolerance model expressed by this method can effectively define and interpret the current national standard of tolerance.
用该方法表示的几何公差模型能合理地、有效地定义和解释当今的国家公差标准。
The general framework and prototype system for synthetic design of dimensional and geometric tolerance based on three- dimensional CAD system are established.
给出了基于三维CAD系统的计算机辅助尺寸公差和形位公差综合设计的总体框架和原型系统。
应用推荐