网络释义专业释义
-
冲压成型 - 引用次数：2
Firstly, simulated the punch forming of the billet with the FEM simulation method, analyzed the metal flow in the deformation process; obtained the formed punch unit pressure distribution situation and how the pressure change with stroke; analyzed the stress situation of the cavity die inwall in the deformation process detailed, and knew how the deformation band, friction condition, deformation degree and deformation material influence the cavity die inwall lateral pressure through changing deformation condition.
首先,采用有限元模拟方法对钢坯的冲压成型过程进行模拟,分析了变形过程中金属的流动变形情况;得到了冲头的单位压力分布及冲头压力随行程的变化情况;详细的分析了变形过程中冲孔模内壁的受力情况,并且通过改变变形条件的方法分别得出了变形区域、摩擦条件、变形程度及变形材料等参数对冲孔模内壁压力的影响。
参考来源 - 无缝钢管管坯冲孔机金属变形及模具受力分析
·2,447,543篇论文数据，部分数据来源于NoteExpress
双语例句
-
The one-way punch forming process used for brass valve body was introduced, some instructive Suggestions for improving the process were put forward.
针对黄铜阀体单向冲压成形生产中存在的问题，提出了改进措施。
-
In this paper, the research on numerical simulation of punch-forming parameters for automobile frame parts of sheet metal is done by using the non-linear FEM software SHEET-FORMING.
本文以非线性有限元软件包SHEET - FORMING对某汽车落地骨架零件的冲压工艺参数进行数值模拟研究。
应用推荐