Why is there both external and internal pressure to look "perfect"?
为何会有外在和内在的双重压力来让自己看起来“完美”？
In the reversible case, an external pressure is essentially equal to the internal pressure.
在可逆的情况下，外部压力基本上等于内部压力。
This is the internal pressure of the system.
这是内部压强。
Any tumor may compress regions of the brain and increase internal pressure, upsetting the organ's delicate functional balance.
任何肿瘤都会挤压大脑某些区域，增加内部压力，从而打破该器官的微妙运作平衡。
Test by internal pressure (simulation of decompression).
使用内压测试(减压模拟)。
To cause to expand by or as if by internal pressure; dilate.
使膨胀，使肿胀：由内部压力或好象由内部压力而引起膨胀；使肿胀。
The shape of the pick-up's inlet influence the internal pressure much.
集流管进口形状对其内部压力分布有较大影响。
Segmental thrust ring absorbs all the thrust applied by internal pressure.
弧形止推环吸收内部压力施加的全部推力。
Segmental thrust ring absorbs all the thrusts applied by internal pressure.
分段止推环吸收了所有由内部压力产生的推力。
The minimum thickness was mainly determined by the maximal internal pressure.
影响最小厚度的主要因素是最大内部压力。
The test battery exhibited a little higher internal pressure than the reference battery.
实验电池的内压略高于参照电池的内压。
Also, the formulas of allowable internal pressure for various pressure vessels are proposed.
并在此基础上推导了不同压力容器的许可压力公式。
An increase in the temperature of a gas confined in a container will lead to higher internal pressure within the gas.
提高密闭容器内气体的温度会使气体的内压升高。
It also compares the calculation methods of internal pressure load in the new standards with that in the old standards.
同时还对新旧标准套管内压载荷计算方法进行了对比分析。
In the range of research, the tubing failure is not strength calculation problem under internal pressure and axial load.
在所研究的范围内，得出了内压和轴力作用下，油管失效不是油管强度不足的结论。
This paper deals with creep deformation and stresses of a spherical pot under high temperature and uniform internal pressure.
本文对高温、均匀内压作用下球罐的蠕变变形和应力进行了探讨。
In the process of tube hydro forming, the tube changes its shape under combined internal pressure and axial compressive load.
管材内压液力成形过程中，管坯在内压与轴向压力的共同作用下发生变形。
The basis of static pressure test for vessels under external pressure and vacuum vessels being done with internal pressure is elaborated.
阐述了对外压容器和真空容器以内压进行压力试验的理论依据和合理性。
Vessel parts subject to different internal pressure on both sides shall be designed to withstand the most severe combination of the pressures.
容器两侧承受不同内部压力的部件需设计为能经受最大整体压力。
Based on the theory of plasticity, the variety rule of internal pressure and axial force in the process of thin tube bulge forming is studied.
采用塑性变形理论研究了薄壁管液压胀形过程中轴向载荷与内压力的变化情况。
By using the elastoplastic finite element method, mechanical model for wear tension and internal pressure resistance of casing joints is set up.
采用弹塑性有限元方法，建立了套管接头磨损拉伸与抗内压的有限元力学模型。
A clogged pore can only stand so much internal pressure before its walls break, allowing the oil and bacteria to seep under the surrounding skin.
一个堵塞的毛孔的承载量是有限的，当压力过大时毛壁会破裂，油脂和细菌会渗漏到附近的皮肤上。
Finally, the simulation results are verified, and the optimal internal pressure forming curve is built as the reference for the practical tube bending.
最后对模拟结果进行了试验验证，并建立了可供实际推弯工艺参考的最佳内压力成形曲线图。
The critical velocity of the infinite long sandwich shell to moving internal pressure is studied using sandwich shell theory and elastodynamics theory.
基于夹层壳理论和三维弹性动力学理论，研究了无限长夹层圆柱壳在移动内压作用下的临界速度。
At the same charge condition, the larger mass ratio of positive and negative active materials is, the more gas produces, the higher internal pressure is.
相同的充电条件下，正极与负极的活性物质质量比越大，产生的气体越多，内压越高；
It was concluded that high internal pressure was caused by oxygen evolution of positive electrode and slow reducing rate of oxygen in negative electrode.
由此可以判定，内压升高的原因在于正极的析氧及负极氧还原速度的缓慢。
A test and pressure relief valve should be installed to assure relief of internal pressure prior to servicing and as a visual indication of trap operation.
应该安装一个测试和压力安全阀，确保内部压力能够在维修前得到释放，并作为疏水阀工作的直观显示。
Based on the netting theory for the filament-wound structure, the balanced equation of the filament-wound conical case under internal pressure was derived.
以纤维缠绕结构的网格理论为基础，建立了纤维缠绕圆锥壳体在内压作用下的平衡方程。
Based on the netting theory for the filament-wound structure, the balanced equation of the filament-wound conical case under internal pressure was derived.
以纤维缠绕结构的网格理论为基础，建立了纤维缠绕圆锥壳体在内压作用下的平衡方程。
应用推荐