Check your hardware and retry.
检查硬件并重试。
正在等待重试卷影复制…
Each time it happens, click Retry.
每一次发生，请点击重试。
Retrycount设置为2。
If you mess up, it will tell you to retry.
如果你做错了，它会提示你重试。
You can also set the connection retry interval.
您还可以设置连接的重试时间间隔。
Fix the problem and click Cancel to retry.
解决这一问题，单击“取消”重试。
Choose Retry to attempt the operation again.
选择重试尝试该操作。
Please check the scanner and retry the scan.
请检查扫描仪，重新扫描。
This enables the use of "retry" logic if necessary.
这支持在必要时使用“重试”逻辑。
Wait for a few minutes and retry the operation.
等待一段时间，并重新执行这种操作。
To try again using another floppy disk, click Retry.
要用其他的软盘再试一次，请单击“重试”。
'Otherwise you will get the message,' Please retry.
'否则，你将得到消息，'请再审。
The page you visit is updating, please retry later.
您访问的页面正在更新，请稍后再试。
Not ready error reading device. Abort, Retry, Ignore?
读取装置没有准备就绪错误。放弃，再试，忽略？
System Security - Security password retry count exceeded.
系统安全性-超出安全性密码重试次数。
System Security - Security password retry count exceeded.
安全的地方（注意，密码区分大小写）。
Hardware error saving file. Check your hardware and retry.
保存文件时硬件出错。检查硬件并重试。
Then retry the build operation and it will complete successfully.
然后重试构建操作，就会成功完成了。
System Security - IBM Security password retry count exceeded.
系统安全性-超出IBM安全性密码重试次数。
If it is a mobile device, click Retry to try connecting again.
如果是移动设备，请单击“重试”按钮尝试再次连接。
System Security - IBM Security password retry count exceeded.
安全的地方（注意，密码区分大小写）。
The retry counter for card holder verification has been run out.
卡持有者的重试计数已经超过了允许值。
The difference between these numbers is the flow's maximum retry count).
这些数值之间的区别在于消息流的最大重试计数）。
Click Back to change the configuration or click Retry to try again.
单击“上一步”以更改配置或单击“重试”再试一次。
You must enter an update retry interval greater than or equal to 0.
输入的更新重试间隔必须大于或等于0。
Online device disconnected with unsent data. RETRY or OK to lose data.
联机设备断开，有未发送的数据。按RETRY(重试)，或按OK丢弃数据。
Online device disconnected with unsent data. RETRY or OK to lose data.
联机设备断开，有未发送的数据。按RETRY(重试)，或按OK丢弃数据。
应用推荐