Contact heating is caused by I2R power dissipation.
接触发热是由于I2R功耗引起的。
The maximum output current is limited by power dissipation.
最大输出电流受到额定功耗的限制。
The design scheme of CAN bus instrument in exceed low power dissipation is introduced.
介绍了CAN总线仪表在超低功耗时的设计方案。
Its power dissipation and propagation delay time are a tradeoff of the two comparators.
其功耗和传输延迟时间介于两种比较器之间。
Features: high DC current gain, low saturation voltage, high col lector power dissipation.
特点：高直流电增益，饱和压降低，高集电极。
As a computers processing performance continues to increase, so does its power dissipation.
随着计算机处理器性能的不断提高，功耗也在不断增加。
A differential pair dynamic comparator which has no DC power dissipation is used in SUB-ADC.
每级子模块中采用了没有直流功耗的差分对动态比较器，具有更好的综合性能。
The power dissipation model of synchronous rectification flyback converters was established.
建立了同步整流反激变换器的损耗模型。
HT1625 has the characteristics of low power dissipation choice, simple connection and audio output.
HT1625具有低功耗选择，接线简单和音频输出等特点。
This can vary from the minimum pad size for soldering to a pad size given for maximum power dissipation.
这可以从不同的焊接到焊盘尺寸为最大功率耗散，和灰给定的最小焊盘尺寸。
This paper describes a circuit of data exchange with the features of high speed and low power dissipation.
本文介绍一种用于空间及核数据采集系统中的高速数据交换电路它具有低功耗、高速度的特点。
The method for calculating power dissipation and some cautions for thermal design are provided in the end.
最后介绍了计算系统功耗的方法和芯片散热设计的注意事项。
This system has the advantages of small size, low power dissipation and wireless transmission of data etc.
设计的系统具有体积小、功耗低及数据无线传输等优点。
The AD7927 USES advanced design techniques to achieve very low power dissipation at maximum throughput rates.
AD 7927采用先进的设计技术，可在最高吞吐量下实现极低的功耗。
Processing speed and power dissipation are well optimized for special inputs with prejudgment for input data.
并对输入数据进行系数预判，在特定输入情况下，有效提高了处理速度和降低功耗；
The design principle of the trial pump includes micromation, portability, low power dissipation and low cost.
实验泵的设计原则是：微型化、便携式、低功耗、低成本。
We may use some special means to decrease power dissipation and the voltage types of power supply in these systems.
为了减少功耗和电源电压的种类，系统中可以采取一系列特殊措施。
The resistor must also be rated high enough to meet the power dissipation requirements while the zeners are conducting.
该电阻器还应当有足够高的额定功率，以满足齐纳管导通时的功率耗散要求。
Estimation of least upper bound of IC power dissipation Calculating IC power dissipation is a basis for low power design.
IC电源消耗的估计本文提出并实现了一种计算ic电源消耗最小上界的方法。
As the increase of power dissipation and the decrease of power voltage value, voltage drop becomes more and more serious.
随着功耗的增加和电源电压的降低，电压降落变得越来越严重。
And the power dissipation is 0.11W (including switching loss) when supply voltage is 12V. The designed chip was taped out.
此外，芯片在12V供电电压下的稳态工作功耗仅为0.11W（包括开关损耗）。
Heat and Battery Life Issues, Sources of Power Dissipation, Circuit and Algorithm Optimizations for Power, Voltage Scaling.
热量和电池寿命问题，能源消耗，针对能源的电路和运算优化，电压换算。
The EL1528 is a dual channel differential amplifier designed for driving full rate ADSL signals at very low power dissipation.
该EL1528是一种双通道差分放大器设计用于驱动全速率的ADSL信号在非常低的功耗。
This current-decay control scheme results in reduced audible motor noise, increased step accuracy, and reduced power dissipation.
此电流衰减控制方案成果在减少声响马达的噪声，提高一步的准确性，并降低功耗。
Especially, the clock-racing multi-threshold flip-flop can decreases the leakage power and the power dissipation of clock network.
特别是多阈值时钟竞争型触发器，不仅可以降低电路的漏电流功耗，还能降低电路的时钟网络的功耗。
It is the basis of computing the size of switch transistors to derive the model of the power dissipation and efficiency of charge pump.
推导了电荷泵的损耗和效率模型，为电路设计中确定电荷泵开关管的尺寸奠定基础。
The system power dissipation was reduced 50 percent by means of proper device selection, dynamic power management, and low-power coding.
并通过合理的器件选择、动态功耗管理和低功耗编码等设计方法，使系统功耗降低50%。
In path metric update, we adopt In-place path metric updating method that can reduce half of memory space, and lower the power dissipation.
在路径度量的存储更新上采用原位运算的方法，减少了一半的存储器，减少了功耗的使用。
The parasitical capacitances of power devices greatly influence the power dissipation and performance of driver ICs for flat panel display.
功率器件寄生电容的大小直接关系到平板显示器驱动芯片的功耗及性能。
The reduction in size of components and circuits for increasing package density and reducing power dissipation and signal propagation delays.
减少元件和电路的几何尺寸，以达到增加电路的封装密度、减少功耗和减小信号传播延迟的目的。
应用推荐