Now, to manage CPU power dissipation, processor makers favor multi-core chip designs, and software has to be written in a multi-threaded or multi-process manner to take full advantage of the hardware.
当前,为了管理CPU性能损耗,处理器生产厂商倾向于采用多核芯片设计,并且软件必须以多线程或者多进程的方式来编写,从而发挥硬件的最大优势。
These parts use advanced design techniques to achieve very low power dissipation at high throughput rates. They also feature flexible power management options.
这些器件采用先进的设计技术,可在高吞吐量的情况下实现极低的功耗,还提供灵活的功耗管理选项。
Compared with traditional silicon process, SOI has higher speed, lower power dissipation, high integration, better isolation, less parasitic effects, higher reliability, etc.
与传统体硅技术相比,SOI技术具有高速、低功耗、高集成度、良好的隔离、寄生效应小以及可靠性高等优点。
Contact heating is caused by I2R power dissipation.
接触发热是由于I2R功耗引起的。
The maximum output current is limited by power dissipation.
最大输出电流受到额定功耗的限制。
Power dissipation in CMOS circuit is decided mainly by the dynamic power dissipation.
CMOS电路功耗主要由动态功耗决定。
Its power dissipation and propagation delay time are a tradeoff of the two comparators.
其功耗和传输延迟时间介于两种比较器之间。
As a computers processing performance continues to increase, so does its power dissipation.
随着计算机处理器性能的不断提高,功耗也在不断增加。
A differential pair dynamic comparator which has no DC power dissipation is used in SUB-ADC.
每级子模块中采用了没有直流功耗的差分对动态比较器,具有更好的综合性能。
The power dissipation model of synchronous rectification flyback converters was established.
建立了同步整流反激变换器的损耗模型。
The emphasis is put on how to depress the power dissipation of the memory and how to improve its speed.
着重于介绍如何降低存储器的功耗和提高存储器的速度。
This paper describes a circuit of data exchange with the features of high speed and low power dissipation.
本文介绍一种用于空间及核数据采集系统中的高速数据交换电路它具有低功耗、高速度的特点。
The method for calculating power dissipation and some cautions for thermal design are provided in the end.
最后介绍了计算系统功耗的方法和芯片散热设计的注意事项。
This system has the advantages of small size, low power dissipation and wireless transmission of data etc.
设计的系统具有体积小、功耗低及数据无线传输等优点。
The fuzzy controller is a high_speed, low power dissipation system that can be integrated in a single chip.
该模糊控制器是可集成在一块芯片上的高速、低功耗系统。
The drawback of this approach is high power dissipation on series components during the overload condition.
这个方法的缺点是过载情况下,串联器件上能量耗散高。
The AD7927 USES advanced design techniques to achieve very low power dissipation at maximum throughput rates.
AD 7927采用先进的设计技术,可在最高吞吐量下实现极低的功耗。
By employing this new architecture, Renesas aims to reduce code size by 30% and CPU power dissipation by 50%.
通过该架构,瑞萨科技旨在将代码尺寸减小30%,CPU的功率消耗减少50%。
The design principle of the trial pump includes micromation, portability, low power dissipation and low cost.
实验泵的设计原则是:微型化、便携式、低功耗、低成本。
Thus, software radio DDFS based on CORDIC algorithm can help to reduce chip area, power dissipation and cost.
所以CORDIC算法来实现软件无线电直接数字频率合成器有助于节省芯片面积、降低功耗、减少成本。
The main superiorities of TSPD device are small volume, lower power dissipation and precise transition voltage.
TSPD的主要优势在于其小巧的体积、导通状态下较低的功率耗散以及精确的“转折”电压。
Traditional orifice plate flowmeter had some demerits such as low measuring precision and high power dissipation.
传统孔板流量计测量精度较低,功耗较高。
We may use some special means to decrease power dissipation and the voltage types of power supply in these systems.
为了减少功耗和电源电压的种类,系统中可以采取一系列特殊措施。
Switching power amplifier has advantage over volume, efficiency and power dissipation because of its high efficiency.
开关功率放大器由于具有很高的效率,在体积、效率和功耗要求较高的场合具有很大的优势。
When the comparator is designed, much attention is paid to relieve the offset voltage and save the power dissipation.
比较器的设计则重点关注失调电压的消除和功耗的节省。
The resistor must also be rated high enough to meet the power dissipation requirements while the zeners are conducting.
该电阻器还应当有足够高的额定功率,以满足齐纳管导通时的功率耗散要求。
And the power dissipation is 0.11W (including switching loss) when supply voltage is 12V. The designed chip was taped out.
此外,芯片在12V供电电压下的稳态工作功耗仅为0.11W(包括开关损耗)。
The cascode two -stage op -amp and differential dynamic comparator are also used to optimize the speed and power dissipation.
在设计中还采用了共源共栅两级运放和差分动态比较器来优化电路的速度和功耗。
The flow stress was corrected by the constitutive equation and the power dissipation map was obtained using the corrected stress.
由试验得出变形过程中的真应力真应变曲线,并利用本构方程对流变应力值进行修正,进而根据修正后的应力值绘制功率耗散图。
It is the basis of computing the size of switch transistors to derive the model of the power dissipation and efficiency of charge pump.
推导了电荷泵的损耗和效率模型,为电路设计中确定电荷泵开关管的尺寸奠定基础。
应用推荐