The effects of added amount of DCP, the ratio of MAH/DCP, and extrusion conditions on grafting ratio and melt viscosity of products were investigated.
详细考察了过氧化二异丙苯(DCP)用量、MAH/DCP配比以及挤出条件对接枝产物接枝率和熔体粘度的影响。
参考来源 - 聚丙烯接枝反应与接枝物相容性的研究·2,447,543篇论文数据，部分数据来源于NoteExpress
Whereas, with excessive P addition, an extremely low melt viscosity causes balling phenomena.
但若P元素过量时，则会因熔体粘度过低而导致球化现象。
Molding shrinkage of small, good stability, melt viscosity size is small, easy forming process.
成型收缩率小，尺寸稳定性好，熔体粘度小，易成型加工。
The melt viscosity and tensile strength of lithium ionomer increased with the sulfonate content increasing.
随离聚体中磺酸基含量的增加，锂离聚体的熔融黏度和拉伸强度增大。
应用推荐